July 14, 2008

You can see when you look at the windows from the front the dark pieces create a nice shadow effect and block the view of whatever would be on the other side.

This is GOOD :)

Now to do the same for those small gaps at the TOP of the upper ledge.

July 14, 2008

Now you need those TOP pieces, cut out TWO pieces measuring 3.5cm X 11.5cm.

July 14, 2008

Place them FLUSH with the REAR window frame and use the Hot Glue to secure it in place.

July 14, 2008

Now do the same thing once your 2nd window is created.

We now have 4 hole blockers if you want to call them that :)

July 14, 2008

Looking at the front view again, the tops are now dark and we can't see through to the other side.

PERFECT !!! :)

July 14, 2008

Time to build a door.

Print the Door decal and place it on a piece of foamcore. Then cut out along the outer edges and also along the inside door.

Keep the door piece for later .

July 14, 2008

Take the door frame and trace it on a piece of foamcore and cut out an exact copy of the decal shape.

July 14, 2008

Remember to keep this door piece for later...

July 14, 2008

You need to start with 3 pieces, cut TWO pieces that measure 15.5cm x 5cm and ONE 11cm x 5cm

July 14, 2008

Put some Hot Glue along the edge of piece "A" and secure it to the back of the door frame.

Make sure to align it with the outer edge.

July 14, 2008

You can better see how piece "A" is aligned FLUSH with the door frame in this picture.

Repeat the procedure with the "B" piece.

July 14, 2008

Now Hot Glue piece "C" to the door frame. Align it with the top door frame edge.

You can see what I am talking about by looking to the left of the RED letter C.

July 14, 2008

Here the red arrows point at how the roof arrives FLUSH with the door archway.

July 14, 2008

Now take the other door frame and place it on top of the side walls and ceiling.

July 14, 2008

Using your fingers, put some pressure against the front and rear door arches and apply some Hot Glue to the INSIDE ceiling piece.